Orban 5950 Technical Manual Installation 2-15
3) In the Dante network, route audio to and from the 5950.
A Dante device has a number of channels associated with it. These are either transmit (TX) or receive (RX)
channels. Your OPTIMOD provides two Dante stereo transmit channels and two stereo receive channels.
Receive channels and devices are listed down the left side of the grid in the Dante Controller software.
Transmit channels and devices are listed along the top of the grid. Transmit channels are advertised on the
network. A receiver uses this advertisement to establish a subscription to the channel. A transmit channel can
be sent to multiple receivers using unicast or multicast. Receive channels are connected to transmit channels
via a subscription. Each receive channel will receive audio over the network from at most one transmit
channel. The 5950’s Dante inputs are:
x Channel 1 = DANTE 1 LEFT INPUT
x Channel 2 = DANTE 1 RIGHT INPUT
x Channel 3 = DANTE 2 LEFT INPUT
x Channel 4 = DANTE 2 RIGHT INPUT
The 5950’s Dante outputs are:
x Channel 1 = DANTE 1 LEFT OUTPUT
x Channel 2 = DANTE 1 RIGHT OUTPUT
To Next Page
Loading...
