Orban 5950 Technical Manual Operation 3-55
BANDMIX
Think of this section as a graphic equalizer. You can carefully add or reduce the output of each band of processing.
Careful adjustments should be made here as any additional audio gain will drive the main clipper in the OPTIMOD.
If you find increasing the gain of any channel adds unwanted distortion, adjust the attack time of the 5 band
compressor.
The ON/OFF control turns on and off the output of each band. Useful in some aspects, turning off a band of
processing will unmask distortion from neighboring bands, especially with aggressive presets. Orban’s intelligent
clipper design prevents that type of distortion from being audible when all bands are operating, so it is best to
adjust with all 5 options ON.
To Next Page
Loading...
Need help?
General
