Orban 5950 Technical Manual Operation 3-19
Adjusting and using the browser based PC Remote
The 5950 HTML5 application allows you to adjust every parameter in the 5950 audio processor. Each block of
processing is accessible from tabs that are aligned between the meter display and the controls. In the following
pages we will step thru the controls tab-by-tab for an understanding of what you can accomplish with each.
To setup the connection of the browser with the processor, see page 2-27.
SETTING INPUT LEVELS
Navigate to the I/O Settings tab and open it. Select the INPUT tab on the right column. Here you will see
options for input source (Digital or Analog) and the input reference level for both. This is not a traditional gain
trim, you are setting the input gain reference level. Be certain to leave enough headroom when setting this so
it is properly driven by equipment before it.
The reference level VU and PPM (Peak) settings track each other with an offset of 7 dB. This compensates for
the typical indications with program material of a VU meter versus the higher indications on a PPM.
To Next Page
Loading...
Need help?
General
