Orban 5950 Technical Manual Installation 2-23
THE 5950 FRONT PANEL
The 5950 Front Panel was designed for easy navigation through the various menus via touchscreen. Status lights
and a USB port are also incorporated
STATUS LIGHTS
There are four status lights that, at a glance, can tell you the current operating state of the 5950. They are:
x Power Supply 1 (PS1): When green, the power supply is operating as intended. If flashing red, there is
either no power coming into the supply or there is an issue with the supply.
x Power Supply 2 (PS2): Same functionality as PS1.
x System (SYS): Under normal conditions, this will not be lit. If it is lit, there is some issue with the
processor which should be addressed with Orban technical support. Please do not disassemble the unit.
x Temperature (TEMP): When illuminated, there is an overheating issue with the processor. You should
attempt to remedy the temperature issue in the room, or in the rack where the 5950 is located. To
prevent damage to the unit, if you cannot remedy the temperature situation, you should remove power
to the unit so permanent damage does not occur.
USB PORT
Unused at this time.
TOUCHSCREEN DISPLAY
The heart of the front panel is the navigable touchscreen. As you walk thru the menus of the touchscreen, you will
find that it is easy to make your way to the options you want to adjust.
The default display is the metering for the FM processing. In the upper right hand corner you will see the following
information:
x Active preset
x Active input source
x Date and Time
Below this information are three buttons.
x Main Menu: Will step you into the processing menus
x Headphone Volume: Will open a menu that will show the adjustable volume level and a button to choose
the source feeding the headphones. The options are:
A) FM
To Next Page
Loading...
Need help?
General
