OPTIMOD-AM DIGITAL INSTALLATION
2-51
selected all the numbers in the IP port assigned by your network administra-
tor
D) Press the S
AVE soft button to confirm your setting.
To recall a preset:
Command Response
RP XXXXXXX[PASSCODE]
(valid passcode and preset name)
ON AIR: XXXXXXX
(invalid passcode)
ERROR: [PASSCODE] DOES NOT EXIST
(invalid preset name)
ERROR: XXXXXXX DOES NOT EXIST
In the above table: XXXXXXX is the preset name;
PASSCODE is any valid passcode.
If a non-existent preset name and/or an invalid passcode is entered, the 9400 will
ignore the command.
You can apply this command anytime after the 9400 boots up. The 30-minute
timeout does not apply.
This command is useful in interfacing automation systems to the 9400.
Valid commands are in either upper or lower case, not a combination.
Only one valid command is permitted per line.
The 9400 will not respond to unrecognized commands.
The character code supported is ASCII.
Installing 9400 PC Remote Control Software
This section briefly summarizes the procedure for installing 9400 PC Remote soft-
ware on existing 9400s. If required, you will find more detailed instructions in the
.pdf file automatically installed on your computer by Orban’s installer program,
Setup9400_x.x.x.x.exe, where “x.x.x.x” represents the software version you are
installing. (For example, for version 1.0 software, this would be 1.0.0.0.)
The PC Remote software is supplied on a CD shipped with your 9400. You can also
download it from ftp.orban.com/9400
.
Instructions for using the PC Remote software are found in Section 3 of this manual.
To Next Page
Loading...
Need help?
General
