FCC SAR Warning
FCC Statement
NOTE 1:
This model mobile hotspot meets the government’s requirements for exposure to radio
waves. This mobile hotspot is designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal Communications
Commissioner of the U.S. Government: The exposure standard for wireless mobile hotspots
employ a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR
limit set by the FCC is 1.6W/kg. Tests for SAR are conducted using standard operating
positions accepted by the FCC with the mobile hotspot transmitting at its highest certified
power level in all tested
frequency bands. The SAR guideline includes a considerable safety margin designed to
assure the safety of all persons regardless of age and health. The FCC has granted an
Equipment Authorization for this model mobile hotspot with all reported SAR levels
evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this
model mobile hotspot is on file with the FCC and can be found under the Display Grant
section of
This Product has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This Product generates
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interreference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
Product does cause harmful interference to radio or television reception, which can be
determined by turning the Product off and on, the user is encouraged to try to correct the
interference by one or more of
the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and the receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
This Product complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This Product may not cause harmful interference, and
(2) This Product must accept any interference received, including interreference that
may cause undesired operation.
To Next Page
Loading...
