26 27
DripMaster
®
SECTION
8
A
4-in-1 Drip Irrigation Valve
B
1/2" Drip Tubing Adapter
C
1/2" Distribution/Supply Line
2
Run Distribution/Supply Line next to plants, shrubs and trees you
intend to water. Next install a 1/2" End Cap. Use 1/2" Loop Stakes to hold
the line in place.
3
Hole Punch—Punch a hole in the
1/2" Distribution/Supply Line for
each shrub or tree. Next insert a 1/4"
Barbed Coupler into each hole.
4
Connect the 1/4" Distribution/
Supply Line to each of the exposed
Barbed Couplers and run it to the
base of each shrub or tree. Cut tubing
to desired length.
IMPORTANT: A single 1/4" Distribution/Supply Line should not
exceed 30'.
Common Projects
A
B
C
3
4
5
Remove the 1/2" End Cap and turn on water to flush 1/2" Distribution/
Supply Line, then replace cap to flush 1/4" Distribution/Supply Lines.
6
Attach a Pressure Compensating Dripper to each 1/4" Distribution/
Supply Line. To hold dripper in place, next to the base of the shrub or tree,
use a Tube Stake.
Note: More than one 1/4"
Distribution/Supply Line (with
Pressure Compensating Dripper) may
be required for large trees or shrubs.
IMPORTANT: Do not attach more
than fifty-seven 2-GPH Pressure
Compensating Drippers to a single
1/2" Distribution/Supply Line
A
Tube Stake
B
Pressure Compensating Dripper
C
1/4" Distribution/Supply Line
Supplies needed:
- 1/2" Distribution/Supply Tubing (part # 67345 or 67346)
- 1/2" End Cap (part # 67462 or 69462)
- 1/2" Loop Stake (part # 65731 or 66731)
- Punch Tool (part # 67756 or 69756)
- 1/4" Barbed Couplers (part # 67402 or 69402)
- 1/4" Distribution/Supply Tube (part # 67300, 67301 or 67303)
- Tube Stakes (part # 65721or 69721)
- Pressure Compensating Dripper (part # 67205, 69205, 67206 or 69206)
5
6
6
A
B
C
Orbit
®
DripMaster
®
| Installation Guide Orbit
®
DripMaster
®
| Installation Guide
To Next Page
Loading...
