❶ Hold and press the power button for 3s. The green indicator is on
and gives out starting sounds to enter standby status. Shortly press
the
「
Distribution network mode button
」
button and the blue indicator
flickers to start networking scanning status.
❷ On the homepage, tap
「
⊕Add device
」
or
「
+
」
at the top right corner
to select
「
Auto obtain UUID mode
」
.
❸
Input the name and password of available Wi-Fi or hotspot and tap
“Next step”.
❹
After a QR code is generated automatically, keep a distance of
10-15cm between the camcorder and the QR code for networking
scanning. It gives out prompts
「
EP7 PRO configuration is
successful
」
and
「
APP configuration is successful
」
during the
scanning; the blue indicator goes solid after the scanning is done;
the window
「
Input device name
」
pops up, and you may input a
user-defined device name and tap
「
Confirm
」
to finish adding the
device.
●In the interface
「
Select a desired Wi-Fi
」
, you may input the password
only if your phone has been connected to any Wi-Fi.
●The QR code scanning may be slow sometimes. You need to know
the following three tips:
❶ Check whether the name and password of the Wi-Fi or hotspot are
correct.
❷ Check whether the Wi-Fi or hotspot is functional. A 2.4G network
has large interferences, so you need to use a 5G network as a
priority.
❸
Shortly press the
「
Distribution network mode button
」
and refresh
the scanning mode for a new scanning.
To Next Page
