● Wireless controller (Optional)
Press it when the camcorder is in standby status
to start, stop video recording.
It flickers once when the Video/Photo button is
pressed.
It is solid while charging through USB cable and it
will go out after the camcorder is fully recharged.
Press it when standby to take a photo and press it
during recording to take a candid shot.
Connect a USB cable for recharging.
●Please use the USB cable provided by the manufacturer to recharge
the wireless controller, and the charger should be 5V/1A.
●The controller response may slow down in case of low battery.
●The charging time is about 1 hour, and the standby time is about 1
week.
●The effective distance for operating the controller is about 5m for
video recording and about 8m for taking photos.
●The effective distance may vary in different battery statuses and
service conditions.
To Next Page
Loading...
