Orion 250i2 EV CNC - Option 2: Mount Welder to Side of CNC Table

6
OPTION 2: MOUNT THE WELDER TO THE SIDE OF THE CNC TABLE
STEP 1: CONNECT THE WELDER TO THE SIDE BRACKET ON THE CNC TABLE
Step 3: Connect the power cable and AC power
1. Plug the power
cable into the
back of the
welder.
2. Plug the other
end into the
power supply
box.
3. Now plug the
AC power cord
into the other
side of the power
supply box .
4. Last, plug the
end of the AC power cord into any standard 110-220VAC outlet.
Step 4: Argon Setup
Use protective shielding gas, such as 99.996% pure Argon (Argon 4.6) or higher.
1. Ensure that your shielding gas tank is securely fastened to a stationary point near the
welding area.
1. 2.
3.