Orisec CK-10 - Page 28

28
Log Event
Description
System Disarmed
System disarmed.
Arming Failed
Arming failed.
Armed With ATS Fault
The system was armed with an Alarm Transmission System (ATS) fault.
Auto Armed
The system was automatically armed.
Auto Disarmed
The system was automatically disarmed.
Remote Armed
The system was automatically armed remotely.
Remote Disarmed
The system was automatically disarmed remotely.
System Power Up
The system was powered up.
AC Failed
The mains AC supply has been switched off.
AC Restore
The mains ac supply has been restored.
Battery Fault #X
Battery fault #? (1: Presence Fail; 2: Load Test Fail).
Battery Restore
Battery fault restored.
Low Battery Alarm
The system standby battery voltage is low (The system is running on
battery only).
Time/Date Changed
The system time and date has been changed.
Engineer on site
The engineer access code has been entered.
Engineer off site
The engineer has logged off.
Bell Fuse Alarm
The bell fuse has gone open circuit (electronic fuse).
Bell Fuse Restore
The bell fuse has restored.
Aux Fuse Alarm
The auxiliary 12V fuse has gone open circuit (electronic fuse).
Aux Fuse Restore
The auxiliary 12V fuse has restored.
Battery Fuse Alarm
The battery fuse has gone open circuit (electronic fuse).
Battery Fuse Restore
The battery fuse has restored.
Network Fuse Alarm
The network fuse has gone open circuit (electronic fuse).
Network Fuse Restore
The network fuse has restored.
Box Tamper Alarm
The control panel box tamper has been activated.
Box Tamper Restore
The control panel box tamper has restored.
Keypad X Tamper
Keypad X box tamper has been activated.
Keypad X Tamp Rest
Keypad X box tamper has restored.
Exp X Tamper Alarm
Expander X tamper alarmed.
Exp X Tamper Restore
Expander X tamper is restored.
Bell X Tamper Alarm
Network Bell X tamper alarmed.
Bell X Tamper Restore
Network Bell X tamper is restored.
Keypad XX Lost
Keypad XX on network lost.
Keypad XX Found
Keypad XX on network found.
Expander XX Lost
Expander XX on network lost.