54
Turn Remote Controlled Outputs On and Off
The control panel has 5 remote controlled outputs that can be switched on and off when the
system is remotely accessed via a touch-tone telephone. Your installer will normally connect
one or more of the remote-controlled outputs to control lighting etc.
To turn on or off the remote-controlled outputs from a remote location, please proceed as
follows:
1. Access your security system as described in the “Remote Access” section.
2. After the main menu has finished playing, enter *9?# (where ? is 1 to 5) on your touch-
tone phone. The system will prompt you with the current output status:
“Output ? Off.”
3. To switch the output to the opposite state, enter *9?# (where ? is 1 to 5) on your touch-
tone phone. The system will prompt you with the new output status:
“Output ? On.”
4. Repeat steps 2 and 3 for other outputs or enter *# to play the main menu.
5. To end the remote access session, enter *99# on your touch-tone phone.
Record and Playback Speech Messages
The system has 15 recordable voice messages; the speech dialler uses messages 1-4 and the
remaining can used for voice annunciation. All messages can be recorded and played back,
providing the system is remotely accessed with either user 00 (engineer) or user 01 (master).
To playback a voice message from a remote location, please proceed as follows:
1. Access your security system as described in the “Remote Access” section.
2. After the main menu has finished playing, enter *7??# (where ?? is 1 to 15) on your
touch-tone phone. The selected message is played back over the telephone.
3. Repeat step 2 for other messages or enter *# to play the main menu.
4. To end the remote access session, enter *99# on your touch-tone phone.
To record a voice message from a remote location, please proceed as follows:
1. Access your security system as described in the “Remote Access” section.
2. After the main menu has finished playing, enter *8?# (where ?? is 1 to 15) on your touch-
tone phone. Speak loud and clear the message you want to record, when finished press
the # key.
3. Repeat step 2 for other messages or enter *# to play the main menu.
4. To end the remote access session, enter *99# on your touch-tone phone.
To Next Page
Loading...
