oset MX-10 Mk.1 - Battery Care and Usage Guidelines; Charging Duration and Battery Health; Safety Precautions for Battery Handling

22
• It normally takes up to seven hours to charge your baery from a fully discharged
condion. Never overcharge. Remove from the charger aer 10 hours maximum.
• Fully charge the baeries before using your OSET electric bike for the rst me.
It is recommended that you fully charge the baery before & aer every ride and that
baeries are never le in a discharged state for an extended length of me.
Always connect the charger to the baery before connecng the charger to the AC power
source.
Always disconnect the AC power source from the wall socket before disconnecng the
charger from the bike.
Do not block the fan vent on the charger while charging the baery. This can cause the
charger to overheat.
CAUTION
OSET electric bikes must be charged indoors. If the baery, charger or any
connecons become wet, immediately unplug the charger and thoroughly dry all
components prior to charging the baery.
NO LIQUIDS NEAR CHARGER
Avoid any contact with all uids while charging and cleaning the baery. If the
baery, charger or any connecons become wet, immediately unplug the charger
and thoroughly dry all components prior to charging the baery.
DO NOT SPRAY WITH WATER
Keep the baery away from excessive heat and/or open ames. Avoid long term
exposure to direct rays from the sun. Exposing to open ames will result in damage to
the unit leading to possible injury.
DO NOT EXPOSE TO OPEN FLAMES
Never short circuit the discharge terminals of the baeries, i.e touching the contacts to-
gether via a tool, etc. A short circuit will damage the baery and could cause a re resulng
in severe injury and property damage.
WARNING
DO NOT use this baery with any other vehicle or appliance. Use of this baery with any
other product will void the warranty, and may create a hazardous condion that could cause
a re resulng in severe injury and property damage.
WARNING