oset MX-10 Mk.1 - Regular Maintenance Schedule; Pre-Ride and Post-Ride Checks; Periodic Maintenance Intervals

24
MAINTAINING YOUR OSET
Before each ride:
• Check key fasteners are correctly ghtened: Sprocket bolts, wheels nuts, bar and stem
bolts, brake levers and callipers.
• Check throle freely returns to o posion.
• Check chain adjustment.
• Check brakes work and wheels spin freely.
• Check the speed, power and response seng.
• Check the res for proper inaon. Also, inspect the res for damage.
• Check safety lanyard operates correctly
• Ensure baeries are fully charged.
Aer each ride:
• Remove baery, clean and dry your OSET, following OSET’s recommended procedure.
• Ensure grips are intact with bar ends covered, replace if needed.
• Check the wheel spokes for ghtness. It is normal for spokes to loosen in operaon on
the rst few rides. Please check aer the rst 5 rides, and then monthly aerwards.
Every 20 hours of riding:
• Remove wheels and inspect bearings. Re-grease front wheel axle.
• Check swing arm axle bearings and grease axle mang face.
• Check ALL bolts for correct ghtness. Grease where applicable. (I.e Stem bolts)
• Check wiring for corrosion, defects, re-grease all connecons with die electric grease.
• Check wheels are running true and spokes are correctly ghtened.
• Inspect chain and sprockets for wear.
• Check brake lines and pads.
Please refer to component manuals for specic service intervals.
If you have any quesons about the proper care and maintenance of this vehicle, consult
your selling dealer/distributor or contact OSET Customer Service at info@osetbikes.com.
Failure to maintain this vehicle in proper operang condion can lead to an accident
resulng in death or serious injury, and property damage.
WARNING