31
There are no user serviceable elements incorporated into the motor controller, baeries, baery
charger, throle of your OSET electric bike. DO NOT ATTEMPT TO DISASSEMBLE OR ADJUST ANY OF
THESE COMPONENTS. Doing so may cause extensive damage to these components, will void your
warranty and may cause a hazardous situaon. If you cannot resolve a problem using this owners
manual, contact your OSET authorized dealer, or call the OSET Customer Service Department for
assistance.
WARNING
Your OSET is an electric bike, and features a considerable number of electrical components
and wiring. All must be protected from water and dirt! The components are listed below:
Controller: Shown below. This is the ‘brains’ of the drive system. It is a sophiscated and
complex component and is non-serviceable.
Throle: This sends an electronic signal to the controller, which is then interpreted to
determine the power required and the voltage to be sent to the motor. The throle is a
non-serviceable component. It must be protected from water.
The throle contains a small circuit board that can be damaged by water. Similarly, the
connecon between the throle and controller must be protected from water at all mes.
Baeries: There is one, sealed lithium baery included with the OSET bike.
Motor: The motor is the end of the line where the power is actually delivered. The motor is
made up of many components. Any servicing must be carried out by trained technicians only.
Please do not aempt to separate or dismantle the motor in any way.
Relay: The relay is acvated by the switch. It makes a 48v connecon that allows power to be
pulled from the baeries to the controller and ulmately to the motor. The relay has
connecons that should not be touched unless the baeries are disconnected. The relay is a
non-serviceable item. Shown below.
Several other components make up the electrical system, such as the switch, the charge port,
the speed switch, the response dial etc.
Main fuse Relay Controller
To Next Page
Loading...
