46 47
SUSPENSION SETUPSUSPENSION SETUP
21.6
21.5
Adjust the pressure
as required until the
sagged distance
between the seal and
O-ring is 25% of the
overall travel.
Sag measurements
are listed below.
59
The TXP-24 has
rebound damping
adjustment, to slow
the fork / shock’s
return speed and
compression
damping, which
changes the speed
at which the fork
can compress.
Adjust the
pressures, then
rebound damping.
Compression
damping adjustment
should be performed
last.
60
OSET recommend setting suspension components to run 20-25% sag.
These steps should achieve 20-25% as a starting point which can then be tuned softer
(more sag) or firmer (less sag) based on rider preference and terrain.
NOTICE
To ensure an accurate setup during inflation, pause inflating at every 50 psi increment and
compress the bike’s suspension several times, then continue inflating as required.
NOTICE
40 88 40 2.8 82 5.7
45 99 45 3.1 93 6.4
50 110 49 3.4 103 7.1
55 121 54 3.7 113 7.8
60 132 59 4.1 124 8.6
65 143 64 4. 4 134 9.2
70 154 68 4.7 145 10.0
75 165 73 5.0 155 10.7
80 176 78 5.4 165 11.4
85 187 83 5.7 176 12.1
90 198 88 6.1 186 12.8
TXP-24 160mm / 6.3” 38mm / 1.5” 50mm / 2.0” 12mm / 0.5”
To Next Page
Loading...