4.4.3 Sel·Rep Recording
Sel·Rep operation means that the tape is reproduced with the Record Head instead of
being reproduced with the Reproduce Head. With this operation, the signal reproduced
with the Record head is recorded to the other track without time delay. The following is the
procedure of the Sel·Rep operation.
1. Rewind the tape to the starting point of the Sel·Rep operation.
2. Press the RECORD READY button of the recording channel to place it in the
READY position.
3. Set the MONITOR button of the channel to to be recorded to the SOURCE
position (not depressed). Set the Monitor button of the channel to be
monitored to TAPE.
4. Adjust the Input Level knob of each channel so that the VU meter indicates 0
VU. (With this level setting, the peak indicator sometimes illuminates.)
5. Press the SEL·REP mode button of the channel being monitored to the
Sel·Rep position.
6. Press the PLAY button to begin playback.
When the RECORD button is pressed at the overdubbing point, the channel set to
READY is changed to INPUT mode and recording begins.
7. Press the STOP button to stop recording.
When ready to Punch Out, press the PLAY button at the end of the recording.
4.4.4 Fast Wind and Cue Monitor
Pressing the F.FWD button places the machine into fast wind mode. Pressing the RWD
button places the machine in rewind mode. The machine can enter these modes from any
mode other than Edit mode. When the machine is in Fast Forward or Rewind mode, the
tape is normally lifted away from the heads. To monitor the signal on the tape while fast
winding press the CUE button. When the CUE button is pressed the lifters are retracted
and the tape comes into contact with the heads. There are two methods of operating the
CUE button as described below.
Tapping the CUE button
Tapping the CUE button momentarily retracts the lifters and allows the tape to make contact
with the heads so that the tape can be monitored. Tapping the CUE button again raises the
lifters.
Holding the CUE button down
Holding the CUE button down retracts the lifters for as long as the button is held down.
MX-5050mkIV-2/BIII-2 Operation and Maintenance Manual
1999-02 25
To Next Page
Loading...
