4.4.5 Tape Editing
1. Move the tape at the beginning of the edit section. When the tape reaches
to the editing point, rotate the reel by hand to accurately locate the editing
point, and finally place the editing point to the reproduce head.
2. Press the EDIT button to enter the EDIT Ready mode.
The EDIT button blinks to show that the machine is in Edit Ready mode.
3. Mark the point at the Repro Head with a marker pen.
4. Draw out the tape from the Head Assembly. Place the tape on the Splicing
Block. Cut the tape along with the slot on the Splicing Block.
5. While holding the unnecessary part of the tape, thread the tape between the
Pinch Roller and Capstan Shaft.
6. Press the PLAY button and the tape will spill off from the right end of the
transport to the floor.
The EDIT and PLAY buttons illuminate to tell the machine is in EDIT mode.
7. When the tape reaches to the end of the edit section, press the STOP button
to stop the machine.
Repeat step 3 and 4 and splice the tape until the desirable edited tape is
obtained.
To Next Page
Loading...
