36
OTICON AGIL FITTING GUIDE
37
Changing from Mould to Dome
1. Remove Receiver unit from Power Mould as shown
on page 33.
2. Attach dome housing to the Receiver unit as shown.
First, insert the gasget on to the Receiver unit
as shown.
A new Receiver gasget seal must be used each time
the Receiver unit is attached to the shell.
Slide the Receiver gasget along. Do not roll it.
3. Mount the transparent dome housing onto Receiver unit.
4. Fix the Receiver unit by a locking plate.
5. Place the transparent cover on the dome housing.
2
3
4
5
To Next Page
Loading...
Need help?
General
