Owon PDS5022S - Technical Specifications

User’s Manual of OWON Colour Digital Storage Oscilloscope
84
Appendix A: Technical Specifications
Unless otherwise specified, the technical specifications applied are applicable to the
probe with the attenuation switch setting 10X and the PDS series digital oscilloscope.
Only if the oscilloscope fulfill the following two conditions at first, can these
specification standards be reached.
 This instrument should run for more than 30 minutes continuously under the
specified operating temperature.
 If the change range of the operating temperature is up to or exceeds 5℃, open the
system function menu and execute the “Self-calibration” procedure.
All specification standards can be fulfilled, except one(s) marked with the word
“Typical”.
Characteristic Instruction
Bandwidth
●25MHz ---- PDS5022S
●40MHz ---- PDS6042S
●60MHz ---- PDS6062S, PDS6062T, PDS7062T
●
100MHz ---- PDS7102T
Channel 2 + 1 (External)
Mode Normal, Peak detect, Averaging
Acquisition：
Sample rate
(real time)
●100MS/s ---- PDS5022S
●250MS/s
---PDS6042S, PDS6062S, PDS6062T
●500MS/s ---- PDS7062T, PDS7102T
Input coupling DC, AC , Ground
Input impedance
● 1MΩ±2% ， in parallel with20pF±5pF
---PDS5022S, PDS6042S,PDS6062S,PDS6062T
●1MΩ±2%，in parallel with 15pF±5pF
--- PDS7062T,PDS7102T
Probe attenuation
factor
1X，10X，100X，1000X
Input：
Max. input voltage 300V (PK-PK) （DC + AC PK-PK）
Sampling rate
●10S/s～100MS/s---- PDS5022S
●10S/s～250MS/s
---- PDS6042S, PDS6062S, PDS6062T
●1S/s～500MS/s ---- PDS7062T, PDS7102T
Horizontal
System：
Interpolation
（sin x）/x