Oxygen LEPTON - Controls on the Right Handlebar (Fig. 6)

To Next Page

To Previous Page

o In order to zeroize the latter function. keep the button pressed for 5 sec.

CONTROLS ON THE RIGHT HANDLEBAR (FIG. 6)

1) Light swltch

The lights come on when the switch is set to " " .

2) Standard drive mode control

This enables the scooter to be started ridden in normal mode

at a maximum speed of 45 km/h. The relevant indicator light on

the dashboard lights to advise that the control has been

switched on.

3) Sprint mode control

This enables the rider to shift from standard drive to sprint

mode when pressed for a few seconds.

This shift must be made whilst the scooter is powered and

enabled, but at a very low speed or at a standstill.

The relevant indicator light on the dashboard lights to advise

that the control has been switched on.

N.B.: the same conditions must be observed when returning to the standard drive mode.

Fig. 6