Oxygen LEPTON - Operating Instruction; Starting; Stopping and Parking

To Next Page

To Previous Page

OPERATING INSTRUCTION

STARTING

1. Set the ignition switch to " " (FIG. 7). The lights on the dashboard come on for a second as the test check

is run. The message CODE appears on the LCD display.

2. Insert the electronic security key which enables the scooter to be started and disables the anti-theft device. The

standard drive mode light starts to flash. The electronic key can now be removed and the scooter remains

enabled.

3. Press the standard drive mode control (FIG. 6, pos. 2). The corresponding light (FIG. 4, pos. 5) stops blinking

and remains steadily lit, indicating the engine is ready to be started.

STOPPING AND PARKING

1. Release the electronic throttle, stop the scooter by pulling on the brakes, set the ignition switch to " " (FIG.

7) and remove the electronic security key. This causes the power supply to be cut off and the scooter disabled,

with the anti-theft device being re-enabled.

N.B.: The Lepton features a security function called "stand by" which is enabled when the standard drive mode

control is pressed quickly twice in a row. When in this status, the vehicle is not enabled to start, even though all its

functions are active. When pressed again, the standard drive control restores the initial situation.