Oxygen LEPTON - Rear Wheel; Greasing the Rear Brake Ogive (Fig. 20)

To Next Page

To Previous Page

Reassembly

1. Refit the device connecting to the odometer, inserting its tab into the

hole on the wheel hub along with the relevant spacers.

2. Once the wheel pin (2 -FIG. 19) has been inserted, compress the fork

so as to align the tubes.

3. Tighten the wheel pin nut up firmly (1 .FIG. 18).

N.B.: Pull the brake lever repeatedly in order to make sure the braking

system is working properly.

REAR WHEEL

Disassembly

-Set the scooter on the stand.

1. Remove the nut cover.

2. Unscrew the wheel nut.

3. Slide out the wheel.

Reassembly

-Follow the above procedure in the reverse order.

GREASING THE REAR BRAKE OGIVE (FIG. 20)

1. Every 4,000 km, grease the rear brake ogive as follows:

Fig. 20

Fig. 19