BATTERY MANAGEMENT
When the battery low warning light starts flashing, the amount of energy contained in the batteries is sufficient to
cover a distance of less than 15 km.
The battery low warning light remains steadily lit when the energy reserve is sufficient to cover a distance of less than
10 km.
In order not to compromise battery performance, it is advisable to charge the batteries (or stop off at a service centre
to have them changed) when the remaining runtime indicated in the LCD strip of the dashboard is equivalent to less
than 5 km.
N.B.: Below this threshold, the charge status detection system may not be able to determine the battery
runtime in km with a sufficient degree of accuracy.
BATTERY CHARGER
In order to recharge the batteries with the Lepton DRIVE's built-in battery charger, first set the ignition switch to OFF,
lift the saddle and connect the cable to the mains. Keep the saddle lifted whilst recharging is in progress.
The battery charger detects the presence of the voltage and switches on.
The plug warning light on the dashboard (FIG. 4, pos. 2) comes on and an additional disabling function makes it
impossible for the scooter to be started whilst the battery charger is working.
The DRIVE goes into "stand by" mode and the message "stby" therefore appears on the speedometer LCD strip.
During the charging process, take extreme care as the DRIVE surface may become as hot as 60°C and, therefore,
must not be touched.
To Next Page
Loading...