During the charging process the plug warning light on the dashboard (FIG. 4, pos. 2) is flashing, once 80% of the
charging is reached, light remain on, to switch off once the charging is complete.
The life of the batteries and their efficiency improve if recharging is performed frequently.
It is advisable to connect the scooter to the 220 V mains as soon as possible, even after covering rather short
distances, so as to exploit alI the power to the full.
Only charge the batteries with the DRIVE.s specific built-in charger.
Do not use battery chargers designed for other battery types with a different voltage and capacity.
Safety instructions:
ATTENTION: To reduce the risk of electric shock, do not remove cover. Refer servicing to qualified service
personnel.
Battery charger has been designed to provide safety and reliable. It is necessary to observe the following precautions
in order to avoid damage to persons and to the battery charger:
o Read the installation instructions contained in this Manual carefully.
o When you use the charger you have care that the fan work well. Don't cover the charger when it work.
o When use the charger the saddle must be open and the ignition key switch to OFF
o Ensure all ventilation ports are not obstructed, to avoid the overheating. Do not put the battery charger
near heat sources. Make sure that free space around the battery charger is sufficient to provide adequate
ventilation and an easy access to cables sockets.
o Verify that the available supply voltage corresponds to the voltage that of the battery charger. In case of
doubt, consult a retailer or local Electric Supply Authority.
o For safety and electromagnetic compatibility, the battery charger has a 3-prong plug as a safety feature,
and it will only fit into an earthed outlet. If you can not plug it in, chances are you have an older, non-
earthed outlet; contact an electrician to have the outlet replaced. Do not use an adapter to defeat the
To Next Page
Loading...