Oxygen LEPTON - Checking the Rear Reduction Gear Oil Level (Fig.17)

28
o never improvise or perform work using unreliable tools; use correct tools only!
o it is forbidden to wear rings, bracelets, or watches with metal straps or buckles when working on the
batteries!
o make sure the connectors are fastened properly.
o The batteries must not be allowed to work in airtight rooms.
CHECKING THE REAR REDUCTION GEAR OIL LEVEL (FIG.17)
Check the level of the rear reduction gear oil every 5,000 km or
once a year. Proceed as follows:
1. Run the engine until it reaches the regular working
temperature, then switch it off.
2. Set the scooter on the stand.
3. Piace a graduated receptacle, with a capacity of
120cm3or over, under the drain plug (2).
4. Unscrew and remove the filler cap (1) and oil drain
plug (2).
5. Let ali the oil drain out of the oil sump, measure the
quantity; if it is less than 40 cm3, top up with the
missing quantity.
6. Tighten the drain plug (2) and proceed with filling.
7. Tighten the filler cap (1 ).
Fig. 17