Oxygen LEPTON - Removing the Headlight Fairing (Fig. 23); Adjusting the Headlight Beam (Fig. 24)

32
REMOVING THE HEADLIGHT FAIRING (FIG. 23)
In order to remove the fairing (FIG. 23), unscrew the fastening screws and then
slide it out, taking extreme care not to snap the centring tabs.
ADJUSTING THE HEADLIGHT BEAM (FIG. 24)
The headlight beam can be adjusted by turning the relevant screw with a
screwdriver (1 -FIG. 24).
Turn clockwise to raise the beam and anticlockwise to lower it.
The headlight beam must always be parallel to the ground.
Fig. 23
Fig. 24