Oxygen LEPTON - Checkingthe Steering (Fig. 21); Checking the Engine Fulcrum Axis (Fig. 22)

31
2. Disassemble the rear wheel.
3. Release the rear wheel cable from the arm by loosening the adjusting screw.
4. Disassemble the brake shoes (2 -FIG. 20)
5. Remove the brake lever (1 -FIG. 20) by loosening the nut (3 -FIG. 20).
6. Remove the pin (4- FIG. 20).
7. Only grease the area indicated by the arrow.
8. Reassemble by following the procedure in the reverse order.
WARNING: Take extreme care not to grease the pln (4) in the cam area and not to dirty any parts or areas
other than those Indlcated wlth the grease as this is Ilkely to compromise
braking efficiency.
CHECKINGTHE STEERING (FIG. 21)
Every now and again, check for slack steering.
1. Set the scooter on the stand.
2. Shake the fork in the direction of travel (FIG. 22).
3. If there is considerable slack, contact a service centre
CHECKING THE ENGINE FULCRUM AXIS (FIG. 22)
The engine should be checked periodically for slack between the engine pin
bushes and the actual engine pin.
1. Set the scooter on the stand.
2. Push and pull the rear wheel sideways (FIG. 22).
3. If there is considerable slack, contact a service centre.
Fig. 22
Fig. 21