EasyManua.ls Logo

PABX CDX-CP832 - Call Switch (Call Pick up During Conversation); Call Waiting(R-Key Function)(Optional); Intercom Calling; Intercom Calling at Direct-Dialing-Out Mode

PABX CDX-CP832
61 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
---------------------------------------------------------------------------------------------------------------------------------
40
5.18 Call Switch (call pick up during conversation)
While an Ext. talking with a CO. line , an Ext. or a doorphone, the other CO. line calling in or
the other doorphone call in and should ring this Ext., you will hear prompts beep tone( the beep
for doorphone calling and CO. line calling is different). Then you can:
Operation: for normal phone, Pat the hook (or press the FLASH button), then you will hear dial
tone, press “# 9” to switch another Co.line, also you can switch to receive the call
from door phone. The first conversation now is be holded(for CO.line talking ,the
holding time can be set in chapter 4, but for the conversion with doorphone will be
ended ), when you talking with the second call,you also can Pat the hook and press
# 9 to take back the first holding call.
Note:
1 when there are some calling at the same time ,CO.line calling is the prior grade to be
switch, and door phone calling is second , the Co. line hold is in the third grade.
2 For key phone you should press transfer key instead of Pat the hook.
3 Answer incoming waiting call by # 9 and take back the first one by # 9 again can be
repeatable as long as the you like for CO.line, but for doorphone you can only switch one
time.
4 The waiting incoming call beep(prompt beep) are different for the door phone call and the
CO.line call ; The doorphone calling prompt beep is two beep(du du ),and the CO.line
calling prompt beep is three brief beep(du du du)
5.19 Call waiting(R-Key function)(optional)
Format: Pat the hook (or press the FLASH button) dial # 8 while talking with C.O.line
Description: During communications between extension and C.O. line, use this command on
extension as a flash action, as telephone’ R key in CO line, this is always used for switching the
call waiting.
This function must be applied from your telecom service provider before using.
5.20 Intercom calling
5.20.1 Intercom calling at direct-dialing-out mode
Format: * + Ext number
Description: Make internal call from Ext. with direct-dialing-out mode. And the system allow you to
redial.

Table of Contents

Related product manuals