27
Switching on the Tail Lift
Depending on the model there are four ways to switch on the
tail lift:
• Switch in driver's cab
• Key control at lateral operating element
• Key code at lateral operating element
• Battery main switch
To switch on the tail lift using the switch in the driver's cab:
Set the switch in the driver's cab to "ON".
The switch marking is no longer visible.
The operational readiness of the tail lift is shown by an op-
tical signal in the driver's cab.
If the vehicle is equipped with a starter interlock, the vehicle
cannot be started.
To switch on the tail lift using the key control (26) at the lateral
operating element:
Insert the key into the keyhole of the key control and turn it
clockwise.
The operational readiness of the tail lift is shown by an op-
tical signal in the driver's cab.
CAUTION!
Risk of injury or material damage due to insufficient
safety measures!
Personnel can be injured and material damage can occur at
your vehicle, the tail lift, or other vehicles if you do not ob-
serve the following:
Prior to starting work, be sure that all safety and warning
devices are present and operational.
Only stop in places where the traffic regulations permit a
stop.
Secure the vehicle against rolling away, for example by
using the parking brake, engaging a gear, or wheel
chocks.
Secure the traffic area with warning flags and warning
lights before loading or unloading the vehicle. Pay special
attention to secure the operating elements of the tail lift
that stick out into the moving traffic.
Betriebsanleitung_Hubladebuehnen_EN.book Seite 27 Donnerstag, 15. August 2019 4:04 16
To Next Page
Loading...
Need help?
General
