Panametrics T5 - Nozzle Installation Kit and Pipe Preparation

Chapter 1. Installing Pipe Nozzles
2 T5 Flare Gas Transducer Installation Guide
1.2.1 Identifying and Checking the Nozzle Installation Kit Components
The Nozzle Installation Kit contains the materials listed below. Use Figure 1 below to help identify each component.
• 2 Nozzles (if purchased)
• 2 Welding bosses
• 1 Jig
• 1 Alignment plate (9”, 10” or 6.4” spacing)
• 1 Spacer flange
• 1 Threaded rod (1” diameter), with washer and nut
IMPORTANT: You will need eight 5/8” studs with two nuts each, or 3/4” studs with two nuts each. The 5/8” studs are
needed for 2”-150#, 2”-300# and 3”-150# flanges. The 3/4” studs are needed for 3”-300# flanges.
After you are familiar with each component, verify that the welding bosses and alignment plate shipped are for the
required transducer spacing and the pipe size described in the following steps.
Figure 1: Components for Nozzle Installation Kit
Welding Boss
Nozzle
Jig
Spacer Flange
Alignment
Threaded Rod
with Washer and Nut
Plate