T5 Flare Gas Transducer Installation Guide 17
Chapter 1. Installing Pipe Nozzles
1.3.2 Selecting and Marking the First Nozzle Location (cont.)
2. Install the pipe nozzles on a pipe diameter as near as possible to the horizontal plane. This would be at the
3 o’clock and 9 o’clock positions for a horizontal pipe.
Note:
If you cannot find a proper location, please consult with Panametrics Flow Application engineering.
3. At the 3 o’clock position, center punch the pipe to mark the position for the center of the first nozzle.
4. Spray this area with a marking dye product. Using a metal straight edge, scribe 6 in. long vertical and horizontal
lines that intersect at the center punch mark.
To Next Page