- 163 -
Selects the level of the DRS function.
1 Touch [DRS EFFECT].
2 Touch / to select the setting item.
≥ Higher the value, greater the compression level of the highly illuminated area.
≥ Higher the value, greater the noise of the dark area.
3 Touch [EXIT] to exit the menu screen.
≥ This item is not available in the following cases:
j During Super Slow Recording (l 106)
j In Variable Frame Rate Mode (l 103)
This enables/disables Auto Iris Level. (l 69)
Adjusting brightness during the Auto Iris Mode. (l 69)
1 Touch [AUTO IRIS LEVEL EFFECT].
2 Touch / to adjust settings.
≥ You can select a value between s50 and r50.
3 Touch [EXIT] to exit the menu screen.
≥ The default setting that is assigned to [F1:] in [FILE SELECT] is “0”.
You can control the noise reduction effect and afterimage intensity by adjusting the noise reduction
setting.
1 Touch [NR CONTROL].
2 Touch / to adjust settings.
≥ You can select a value between s7 and r7.
≥ Adjusting the setting in the minus (s) direction weakens the noise reduction effect, thereby
reducing afterimages. Note that this also tends to increase noise.
≥ Adjusting the setting in the plus (r) direction enhances the noise reduction effect, thereby
reducing noise. Note that this may also cause afterimages to appear more frequently.
3 Touch [EXIT] to exit the menu screen.
≥ The default setting that is assigned to [F1:] in [FILE SELECT] is “0”.
[DRS EFFECT]
[1]/[2]/[3]
[AUTO IRIS LEVEL]
[ON]/[OFF]
[AUTO IRIS LEVEL EFFECT]
[NR CONTROL]
AG-UX180ED(DVQP1171ZA)_E.book 163 ページ ２０１６年１１月２８日 月曜日 午前１１時３２分
To Next Page
Loading...
