87
Preset Position
Click [Setup] button to call out preset position dialog.
Click [Close] button to exit from image adjust dialog.
Select the preset number or home position from drop-down list.
Click [Move] to go to the pre-set position.
Using
to adjust the unit position and click [Set] to register the
To adjust the image in the horizontal or vertical direction (panning or tilting),
left-click the pad and the buttons.
It is possible to operate with the central grid pattern in the dragged state,
with the speed of the pan/tilt increasing as it approaches the outside of the
: Use this to adjust the zoom (magnification) to 1.0x
: Use this to adjust the zoom (magnification) in the “Tele” direction.
: Use this to adjust the zoom (magnification) in the “Wide” direction.
Select the speed at which zoom operations are to be performed.
Click
Auto
to switch between auto and manual focus.
Green
Auto
indicates that the focus is adjusted automatically.
White
Auto
indicates that the focus is adjusted manually.
Click
Near
to adjust the focus in the Near direction.
It does not work during automatic adjustments.
Click
O.T.AF
while the focus is being adjusted manually, the focus will be
temporarily adjusted automatically.
It does not work during automatic adjustments.
Click
Far
to adjust the focus in the Far direction.
It does not work during automatic adjustments.
Click
Auto
to switch between auto and manual adjustment of the brightness.
Green
Auto
indicates that the brightness will be adjusted automatically.
White
Auto
indicates that the brightness can be adjusted manually.
This is only enabled only when [Scene1] or [Scene2] has been selected as
the [Priority Mode] setting.
To Next Page
Loading...
