20
White balance adjustment
(continued)
●
Manual adjustment
(R gain and B gain adjustment)
White balance can be adjusted manually.
● R/B gain adjustments can only be performed when
White Balance Mode is set to “AWB A”, “AWB B” or
“VAR”.
Note
When performing the operations
using the wireless remote control
● Steps
1 through 6 represent the procedure for selecting
the “AWB A”, “AWB B” or “VAR” memory. They need not
be taken if a selection has already been made.
1 Select Manual1, Manual2 or Manual3 as the
shooting mode by following the procedure in
“Selecting the shooting modes (scene files)”
(page 10).
** Camera **
Scene Manual1
Contrast
Picture
Matrix
Return
2 Press the [▲] or [▼] button to bring the cursor
to “Picture”.
3 Press the [
○
] button.
The “Picture 1/3” sub-menu is displayed.
*** Picture 1/3 ***
Chroma Level 0
White Balance Mode VAR
Color Temperature 3200K
R Gain 0
B Gain 0
Pedestal 0
Return
4 Press the [▲] or [▼] button to bring the cursor
to “White Balance Mode”.
5 Press the [
○
] button.
“White Balance Mode” starts blinking.
6 Press the [▲] or [▼] button to change the
White Balance Mode to “AWB A”, “AWB B” or
“VAR”, and press the [
○
] button to confirm the
selection.
7 Press the [▲] or [▼] button to bring the cursor
to “R Gain” or “B Gain.”
8 Press the [
○
] button to make the “R Gain” or
“B Gain” value blink.
9 Press the [▲] or [▼] button to change the
“R Gain” or “B Gain” numerical value, and
press the [
○
] button to enter the setting.
When performing the operations using the controller
When using an AW-RP50, AW-RP120 or AK-HRP200:
Refer to the Operating Instructions of the controller.
To Next Page
Loading...
