Panasonic AW-HE40HWP

8
How to turn the power on and off
(continued)
■Turning the power off
When performing the operations
using the wireless remote control
1 Press one of the [CAM1] to [CAM4] buttons on
the wireless remote control to select the unit.
2 Press the [ON/STANDBY] button on the
wireless remote control for 2 seconds.
The unit enters STANDBY mode.
● The unit’s status display lamp now lights up orange.
3 If a multiple number of units are used, repeat
steps
1 and 2 as required.
4 Set all the power switches of the units and
devices connected in the system to OFF.
● When transferring to the STANDBY mode
(Status display lamp: Orange)
The pan/tilt position is stored in the memory, and the
pan/tilt unit is moved so that it points backwards.
● When transferring to the POWER ON mode
(Status display lamp: Green (after the initial setting
operation is completed))
The pan/tilt unit is moved to the position which was
stored in the memory when the transition to the
STANDBY mode was made.
● POWER ON preset
The pan/tilt unit is moved to the setting, which was
established immediately prior to the transition to the
STANDBY mode, when the power has been turned
on.
● If the power is turned off without transferring to the
STANDBY mode, the pan/tilt unit position will not
be stored in the memory or reflected in the POWER
ON preset. The previous POWER ON preset will be
applied.
Notes
When performing the operations using the controller
When using an AW-RP50, AW-RP120 or AK-HRP200:
Refer to the Operating Instructions of the controller.