Panasonic AW-HN40HKPC - System Example 5 (Infrared Output Connection); System Example 6 (IP Image Transmission, Poe+)

24
Connections
(continued)
■System example 5 (infrared output connection)
You can point the infrared remote control of a commercially available controller toward the camera to operate it.
RS-232C cable
(including infrared remote
control signals)
RS-232C
connector
RS-232C connector
Commercially
available controller
AW-HN40/AW-HN38
MonitorSupplied AC adaptor
Remote camera control signal
Infrared remote control supplied with
commercially available controller
● Configure the service switches at the bottom of the unit.
For details on the service switches, see “Service switch settings” (page 42).
SW6 Infrared output Set to ON.
■System example 6 (IP image transmission, PoE+)
AW-HN40/AW-HN38
IP decoder
(commercially available)
Monitor
Monitor 1
PoE+ compatible switching hub
Personal computer
LAN cable
LAN cable