Limiters
This unit comes with settings (referred to as “limiters”) that restrict the
panning and tilting movement ranges.
Depending on the installation location, obstacles that may come into
contact with the remote camera may exist within its movement range.
In such cases, setting the limiters before the obstacles will prevent
contact.
The positions of four limiters — namely, the upper, lower, leftmost and
right-most limits of the travel range — can be set.
Once they have been set, the positions will not be lost even after the
power has been turned off.
The limiters can be set or released both by the wireless remote control
and controller or web setting screen [Setup].
Whatever was set or released last takes precedence.
For the controller operations, refer to the Operating Instructions of the
controller.
The settings of the limiters using the wireless remote control will be
described here.
162
To Next Page
Loading...
