z Limitation Setting
This establishes the up, down, left and right limit settings of the pan-tilt
head.
First, use the control pad to rotate the pan-tilt head to the position you
want to set as the limit.
After the limit position has been selected, click the buttons
corresponding to the following items to confirm.
The setting is cleared if the button is pressed again.
Tilt Up Use this to save the current position as the upward limit.
Tilt Down Use this to save the current position as the downward limit.
Pan Left Use this to save the current position as the leftward limit.
Pan Right Use this to save the current position as the rightward limit.
z Pan/Tilt Lens Control
This is used for camera control. The same operations are possible
as with the camera controller operated in the live screen [Live].
(→ page 81)
Speed With Zoom Position [Off, On]
[Off] or [On] is set here for the function used to adjust the pan-tilt
adjustment speed in conjunction with the zoom magnification.
When [On] is set, the panning and tilting operations will become
slower in the zoom status.
This function has no effect during preset operations.
Factory settings: On
Focus Adjust With PTZ. [Off, On]
[Off] or [On] is set here for the function which compensates for out-of-
focusing when it occurs during panning, tilting or zooming operations.
When [Off] is set, adjust the focus as required after zooming or set
[Focus Mode] to [Auto].
This is only enabled when [Manual] has been selected as the [Focus
Mode] setting.
Factory settings: Off
z Preset Setting
Preset Speed Unit [Speed Table, Time]
When reproducing the information such as camera direction
registered in the preset memory, you can select whether to specify
the playback time by speed or by time.
Speed Table Specify the speed when playing during preset
playback.
Time Specify the time when playing during preset playback.
Factory settings: Speed Table
Preset Speed Table [Slow, Fast]
Set the preset speed table (Slow, Fast). During preset playback,
presets are performed at [Preset Speed] (1 to 30) values that are
based on the table set here.
This is only enabled when [Preset Speed Unit] is set to [Speed Table].
Factory settings: Fast
Preset Speed [1 to 30/1s to 99s]
When [Preset Speed Unit] is [Speed Table]: [1 to 30]
Set the pan/tilt operation speed in 30 steps when playing back the
preset memory.
Factory settings: 20
<NOTE>
• When you set large [Preset Speed] values, the image may sway
when the movement stops.
When [Preset Speed Unit] is [Time]: [1s to 99s]
Set the pan/tilt operation time between 1 and 99 seconds when
playing back the preset memory.
Factory settings: 20s
<NOTE>
• Depending on the movement distance of pan/tilt, there may be a
difference compared to the specified time.
Preset Scope [Mode A, Mode B, Mode C]
Selected here are the setting items to be recalled when the contents
of the preset memory are regenerated.
Mode A
Pan, Tilt, Zoom (including digital zoom), Focus, Iris, Gain,
white balance adjustment value
Mode B Pan, Tilt, Zoom (including digital zoom), Focus, Iris
Mode C Pan, Tilt, Zoom (including digital zoom), Focus
Factory settings: Mode A
Preset Digital Extender [Off, On]
Turns the preset digital extender function off/on.
When set to [On], the digital extender function configuration will be
recalled when regenerating the preset memory.
When set to [Off], the digital extender function configuration will not
be recalled when storing the preset memory.
Factory settings: Off
110 111
Web screen configurations (continued)
To Next Page
Loading...
