Panasonic AW-UE150WP - Page 87

z Output 12G SDI/OPTICAL
Make the settings for output from the 12G SDI OUT connector and
Optical connector.
Format
Set the output format.
The following format settings are possible depending on the [Format]
setting in the [System] screen.
Frequency System Format
Format
(12G SDI/OPTICAL)
59.94Hz 2160/59.94p 2160/59.94p
1080/59.94p
2160/29.97p 2160/29.97p
1080/29.97p
1080/29.97PsF
1080/59.94p 1080/59.94p
1080/59.94i 1080/59.94i
1080/29.97p 1080/29.97p
1080/29.97PsF 1080/29.97PsF
1080/23.98p(59.94i)
*
1
1080/23.98p(59.94i)
*
1
720/59.94p 720/59.94p
50Hz 2160/50p 2160/50p
1080/50p
2160/25p 2160/25p
1080/25p
1080/25PsF
1080/50p 1080/50p
1080/50i 1080/50i
1080/25p 1080/25p
1080/25PsF 1080/25PsF
720/50p 720/50p
24Hz 2160/24p 2160/24p
1080/24p
1080/24p 1080/24p
23.98Hz 2160/23.98p 2160/23.98p
1080/23.98p
1080/23.98PsF
1080/23.98p 1080/23.98p
1080/23.98PsF 1080/23.98PsF
*
1
It denotes “1080/23.98p over 59.94i”.
Factory settings: 2160/59.94p (AW-UE150WP/AW-UE150KP)
2160/50p (AW-UE150WE/AW-UE150KE)
HDR Output Select [SDR, HDR(2020), HDR(709)]
Select the signal to be output when [Gamma Mode] is [HLG].
SDR SDR output
HDR(2020) HDR output (BT.2020 equivalent color gamut)
HDR(709) HDR output (BT.709 equivalent color gamut)
Factory settings: HDR(2020)
<NOTE>
• [HDR Output Select] cannot be changed when [Gamma Mode] is
not [HLG]. (→ page 106)
3G SDI Out [LevelA, LevelB]
When [Format] (12G SDI/OPTICAL) is [1080/59.94p] or [1080/50p],
select the format for outputting 3G SDI signals.
LevelA Level A format
LevelB Level B format
Factory settings: LevelA
<NOTE>
• [3G SDI Out] cannot be changed if [Format] (12G SDI/OPTICAL) is
other than [1080/59.94p] or [1080/50p].
86 87
Web screen configurations (continued)