Select the unit (or units) to be operated from the wireless remote control
or controller.
Even when using only one unit, it must still be selected.
When performing operations from a wireless
remote control
Up to four units can be operated using one wireless remote control.
To select this unit with the wireless remote control, set the [Wireless ID]
on the [System] screen from the OSD menu of this unit. (→ page 26)
1. Press the CAMERA <1>, <2>, <3>, or <4> button.
The unit’s status display lamp blinks green when a signal matched by
the remote control ID has been received, and it blinks orange when a
signal that is not matched by the remote control ID has been received.
When performing operations from a controller
A maximum of five units can be operated by one controller when using
serial control.
When using an AW‑RP150 or AW‑RP60
For details, refer to the operating instructions for the controller.
• Network connection with AW-RP150 or AW-RP60 requires setup of an
initial account. (→ page 28)
When an initial account is not set up, AW-RP150 or AW-RP60 can
detect but cannot control this unit.
Selecting the units
32
To Next Page
Loading...
