Operating Instructions
Turn off the power before connecting or
disconnecting the cables.
This unit is not equipped with a power switch.
Disconnect the AC adaptor power plug or turn off the PoE++ power
supply device before connecting or disconnecting cables.
When the unit is not in use
Turn off the unit’s power when it is not in use.
When the unit is no longer going to be used, do not leave it lying
around, but be absolutely sure to dispose of it properly.
Do not touch the optical system parts.
The optical system parts are vital to the operation of the camera.
Under no circumstances must they be touched.
In the unlikely event that they have become dusty, remove the
dust by using a camera blower or by wiping them gently with a lens
cleaning paper.
Do not point the camera directly at the sun or a
laser beam no matter whether it is turned on or
not.
Taking images of the sun, laser beams, or other brightly lit subjects
for prolonged periods of time may damage the CCD.
Personal computer used
If the same image is displayed for a prolonged period on a personal
computer's monitor, the monitor may be damaged. Use of a screen
saver is recommended.
Concerning the IP address setting
Do not run the Easy IP Setup Software on a multiple number of
personal computers for a single camera and set the IP address at
the same time.
Otherwise, you will be unable to complete the proper procedure and
set the IP address correctly.
About consumables
The following parts are consumables. Replace them using the
lifespans as a guide.
The lifespans may vary depending on the operating environment
and operating conditions. The lifespans are a guide for when the
unit is used at 35 °C (95 °F).
• Cooling fan: Approx. 15000 hours
Contact your dealer regarding replacements.
Disposal of the unit
When the unit has reached the end of its service life and is to be
disposed of, ask a qualified contractor to dispose of the unit properly
in order to protect the environment.
Remove lens cap and pan stopper when
turning on power
Make sure you remove the lens cap and pan stopper when turning
on the power.
If there is an error, turn the power on again after removing the lens
cap and pan stopper.
Transportation
The camera unit is constructed to rotate easily. As malfunctions in
camera movement may occur, transport after securing the camera
unit so that it does not rotate.
A Face the lens down, then secure the lens part and camera head
together with tape.
B Use tape to secure the camera head and pedestal in several
locations.
• The lens cap and pan stopper are not intended to guarantee
protection of the camera unit during transport. When transporting
the unit, be sure to use tape to secure it.
Moving the unit
• When carrying the unit, take care not to apply strong shocks or
drop it.
• Remove connection cables when moving the unit.
• Turn off the system power when moving the unit.
• Wrap the unit in cushioning material, etc., when moving the unit so
that impacts do not damage it.
• Treat the unit carefully so that vibrations or impacts do not
damage it.
Information on software used with this product
This product includes GNU General Public License (GPL) and GNU Lesser General Public License (LGPL) licensed software, and the customer is
entitled to obtain, modify, or redistribute the source code for the software.
This product includes MIT Licensed software.
This product includes BSD Licensed software.
For details on obtaining the source codes, visit the following website.
https://pro-av.panasonic.net/
However, do not contact Panasonic for questions regarding obtained source codes.
44 45
Operating precautions (continued)
To Next Page
Loading...
