37
BL-C230A
8.12. Diagnosis NG Check
When turning on the power, CPU makes a check using the self-diagnosis function. Check being able to the access to the device
described below.
When the self-diagnosis function of the device described below is NG turning on the power, CPU makes a check using the LED
indicator red-blinks.
8.13. In Case Where the Main Board Is Replaced and a New MAC Address
Label Is Used
Rewrite the MAC Address of the RF board
1. Turn on the power after replacing the main board (after a new MAC has been written to the main board).
2. Press the Factory Default Reset button after 5 minutes have passed since the power was turned on.
* Do not turn the power off during execution of work.
3. Renew the MAC Address label.
8.14. Update Firmware
8.14.1. Firmware Trouble Shouting
The firmware updating is not completed due to power off, network failure or other causes.
To Next Page
Loading...
