47
BL-C230A
11 Factory Setting
11.1. Resetting the Camera
You can reset all of the camera's settings to their factory default settings.
1. Click the [Maintenance] tab.
2. On the left side of the screen under [Maintenance], click [Reset to Factory Default].
3. Click [Execute].
• The POWER indicator flashes orange, and then turns off for a few seconds.
Note:
• Do not turn off the camera while the camera is being reset. When the lens finishes panning and tilting, it is safe to turn off the
camera.
• When the camera is reset, the following information will be deleted:
- All images buffered in the internal memory
- All alarm logs
- All camera settings (including the user name, password, IP address, subnet mask etc.)
The network connection mode changes to [Automatic Setup]. Reconfigure the camera by referring to the Setup Guide.
• When the camera is reset, the internal clock will not be reset, but the time format will be set to AM/PM mode. Change the setting
if necessary.
11.2. Resetting the Camera Using the FACTORY DEFAULT RESET Button
You can also reset all of the camera’s settings to their factory default settings by pressing the FACTORY DEFAULT RESET button
for about one second with a pointed object.
To Next Page
Loading...
