Panasonic CS-E12RB4UW - Remote Control Button

53
14.3 Remote Control Button
14.3.1 SET Button
 To check remote control transmission code and store the transmission code to EEPROM:
o Press “Set” button continuously for 10 seconds by using pointer.
o Press “Timer Set” button until a “beep” sound is heard as confirmation of transmission code changed.
14.3.2 RESET (RC)
 To clear and restore the remote control setting to factory default.
o Press once to clear the memory.
14.3.3 RESET (AC)
 To restore the unit’s setting to factory default.
o Press once to restore the unit’s setting.
14.3.4 TIMER ▲
 To change indoor unit indicator’s LED intensity.
o Press continuously for 5 seconds.
14.3.5 TIMER ▼
 To change remote control display from Degree Celsius (°C) to Degree Fahrenheit (°F).
o Press continuously for 10 seconds.