15
Before Using
3 Insert the Battery Holder into the Remote
Control.
• When the button-type battery is exhausted, replace
it with a new CR2025 battery. (A battery is normally
expected to last about 1 year. However, it depends
on operation frequency.)
• Make sure to match the poles correctly when
inserting the button-type battery.
● Use Battery with Panasonic type CR2025
only. Use of another battery may present a
risk of fire or explosion.
● Battery may explode if mistreated.
● As with any small object, this type of
Battery can be swallowed by young
children. Do not allow children to handle
this Battery.
● Dispose of used battery promptly.
● Do not recharge, disassemble or dispose
of in fire.
WARNING
CAUTION
Using the Remote Control
(PV-GS69 Only : Optional)
• Distance from the Camcorder: Within
approximately 15 feet (5 meters)
• Angle: Within approximately 15° in the vertical
and horizontal directions from the central axis
1 Direct the Remote Control at the Remote
Control Sensor of the Camcorder and
press an appropriate button.
• The above operating ranges are for indoor use.
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
15°
15°
15°
15°
[VCR1]:
Press the [Ι►] Button and [ ■ ] Button
simultaneously.
1
[VCR2]:
Press the [◄Ι] Button and [ ■ ] Button
simultaneously.
2
• When the battery in the Remote Control is
replaced, the mode is automatically reset to [VCR1]
Mode.
Selecting Remote Control Modes
When 2 Camcorders are used simultaneously,
they can be operated individually by selecting
different Remote Control Modes.
• If the Remote Control Mode of the Camcorder
and that of the Remote Control do not match
with each other, [REMOTE] will appear. When
the Remote Control is operated for the first
time after the Camcorder is turned on, [CHECK
REMOTE MODE] (p. 74) will appear and
operation is impossible. Set the same Remote
Control Mode.
Setup on the Camcorder
Set [ REMOTE] on the [ SETUP] Sub-Menu to
the desired Remote Control Mode. (pp. 27~29)
Setup on the Remote Control
12
Power Supply
Using the AC Adaptor
• Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Camcorder to [OFF] and make sure that
[STATUS] Indicator is not lit. (p. 21)
To Next Page
Loading...
