Recording Mode
33
Recording a Still Picture on a Tape
(PV-GS29 Only)
Still pictures can be recorded on a tape.
• Set to Tape Recording Mode.
1 Press the [PHOTO SHOT] Button in the
Recording Pause mode.
• The Camcorder records a still picture for about
7 seconds and then switches back to the
recording pause mode.
• If you set [
ADVANCED] >> [ SHTR EFFECT]
>> [ON], you can add an image and a sound effect
for releasing the shutter.
• Photoshot recording results in slightly inferior
image quality.
Continuous photoshot
If you set [ ADVANCED] >> [ SHTR EFFECT]
>> [ON] and keep the [PHOTO SHOT] Button
pressed, the Camcorder will continuously record
still pictures in approx. 0.7 seconds intervals until
the button is released.
• The screen blinks and, at the same time, a
shutter clicking sound is recorded.
2 Set the Mode Dial to Card Recording
Mode.
• The [ CARD RECORDING MODE] is
displayed on the screen.
Recording a Still Picture on a Card
(Photoshot)
(For PV-GS39/PV-GS69)
Still pictures can be recorded on the Memory Card
from the Camcorder.
• Open the LCD Monitor or extend the Viewfinder
before turning on the power.
1 Set the [OFF/ON] Switch to [ON].
• The [STATUS] Indicator lights Red.
Selecting the quality of Photoshot
images
1 Set [ BASIC] >> [ PICT.QUALITY] >>
[ (High Picture Quality)] or [ (Normal
Picture Quality)].
• You can also change the picture quality on [
ADVANCED] >> [
PICT. QUALITY] in the
Tape Recording Mode.
Recording with a shutter operation
effect
You can add a shutter operation simulating sound.
1 Set [ ADVANCED] >> [ SHTR EFFECT]
>> [ON].
3 Press the [PHOTO SHOT] Button.
• The [ ] Indication lights up in red.
Maximum number of still pictures
recordable on an SD Memory card
(optional)
PICTURE QUALITY
(High) (Normal)
32 MB 220 440
64 MB 440 880
128 MB 880 1 760
256 MB 1 760 3 520
512 MB 3 520 7 040
1 GB 7 040 14 080
2 GB 14 080 28 160
• The numbers shown in the table are
approximations.
• These figures vary depending on the subject being
photographed.
To Next Page
Loading...
