Playback Mode
47
Playing Back a Tape
The recorded scene can be played back immediately
after the recording.
• Open the LCD Monitor or extend the Viewfinder
before turning on the power.
1 Set the [OFF/ON] Switch to [ON].
• The [STATUS] Indicator lights Red.
2 Set the Mode Dial to Tape Playback Mode.
• The [ TAPE PLAYBACK MODE] is displayed
on the screen.
• The One-Touch Navigation icon is displayed
on the lower right of the screen.
3 Move the Joystick Control [◄] to rewind
the tape.
• Rewind the tape to the point where you want to
start playback.
• When the tape reaches the beginning,
rewinding stops automatically.
4 Move the Joystick Control [▲] to start
playback.
• The [►] Indication appears.
To Stop Playback
Move the Joystick Control [▼] to select [ ].
Adjusting the Sound Volume
• If a cassette recorded with copyright protection
signal is played back, the picture is distorted by
mosaic-like patterns.
Playback Mode
Notes:
• When the adjustment is completed, the volume
indication [
] will disappear.
• If you do not hear the sound, check the settings of
[
SETUP] >> [ 12bit AUDIO].
Adjust the speaker volume for playback.
1 Push the [– / VOL +] Lever to adjust the
volume.
• Towards [+]: increases the volume
Towards [–]: decreases the volume
(Nearer the bar to [+], larger the volume.)
[One-Touch Navigation icon]
Repeat Playback
When the tape end is reached, the tape will be
rewound and played back again.
1 Set [ ADVANCED] >> [ REPEAT PLAY]
>> [ON].
2 Move the Joystick Control [▲] to start
playback.
• The [ ►] Indication appears.
To cancel Repeat Playback Mode
Set [ REPEAT PLAY] >> [OFF] or set [OFF/ON]
Switch to [OFF].
• When you set [
USB FUNCTION] >> [WEB
CAM] and then connect the USB Cable, the
Repeat Playback Mode is canceled.
• If you cannot listen to the desired audio when
playing back a tape, check the settings in
[
SETUP] >> [ 12bit AUDIO].
• When you record or dub the audio in [12bit] and
set [
SETUP] >> [ 12bit AUDIO] >> [MIX],
the audio will be played back in stereo sound
regardless of the settings in [
AUDIO OUT].
Settings on the audio
On the Remote Control, press the [T] Button to
increase the volume or the [W] Button to decrease it.
(PV-GS69 Only)
SP 3h59m59s29f
R 2:00
12:34:56AM
JAN 2 2006 28
SP 3h59m59s29f
R 2:00
12:34:56AM
JAN 2 2006 28
(PV-GS39/
PV-GS69)
(PV-GS29)
To Pause Playback
Move the Joystick Control [▲] to select [ ]
during playback.
To Next Page
Loading...
