18
Re-attaching the Lens Cap
To protect the Lens surface, attach the Lens Cap.
• The Lens Cap and Lens Cap Cord come
preattached to the Grip Belt.
1 Pass one end of the Lens Cap Cord
through the attached eye on the Lens Cap.
Then pass the Lens Cap through the loop
made by itself and pull tight.
2 Fold the end of the Shoulder Strap, run
it through the Shoulder Strap Length
Adjuster, and pull it.
• Pull it out more than 1 inch (2 cm)
1
from
the Shoulder Strap Length Adjuster so that it
cannot slip off.
• Attach the other end of the Shoulder Strap to
the other Shoulder Strap Holder in the same
way.
Inserting/Removing a Cassette
1
• Please use Genuine Panasonic DVC Tapes for
more information please contact your local dealer
or visit www.panasonic.com.
• For your reference if you travel frequently you
should also purchase a Panasonic head cleaning
tape AY-DVMCLA and use when HEAD CLOG
message appears on the LCD/EVF of your
Camcorder.
1 Fit the AC Adaptor or the Battery and turn
on the Power.
2 Slide the [OPEN/EJECT] Lever toward the
front and pull up to fully open the Cassette
Compartment Cover.
• To protect the tape, if the cover is not fully
opened, the cassette holder cannot be ejected.
• When not using the Lens Cap, pull the Lens Cap
Cord in the direction of the arrow.
1
• When you are not recording, be sure to cover the
Lens with the Lens Cap for protection.
2
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap
before going out to avoid dropping the Camcorder.
1 Pull the end of the Shoulder Strap
through the Shoulder Strap Holder on the
Camcorder.
2
1
• When you remove the Lens Cap, press the knobs
firmly.
To Next Page
Loading...
