EasyManua.ls Logo

Panasonic DMR-E95H - Recording Television Programmes; Starting, Pausing, and Stopping Recordings; Recording Media Usage Notes

Panasonic DMR-E95H
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
RQT7467
Recording
Recording television programmes
[HDD] [RAM] [DVD-R]
It is not possible to record to both HDD (Hard disk drive) and DVD
drive simultaneously.
You can record up to 500 titles on HDD, 99 titles on one disc.
It is not possible to record continuously from one side of a double sided
disc to the other. You will need to eject the disc and turn it over.
When using 8 cm DVD-RAM, remove the disc from the cartridge.
It is not possible to record CPRM ( page 55) protected material
onto DVD-R or 2.8 GB DVD-RAM discs.
It is not possible to record to a card.
1 Press [HDD] or [DVD] to select the
recording drive.
The HDD or DVD indicator lights up on the unit.
2 If you selected the DVD drive
Press [< OPEN/CLOSE] on the main
unit to open the tray and insert a disc.
Press the button again to close the tray.
3 Press [WXCH] to select the channel.
To select with the numbered buttons:
4 Press [REC MODE] to select the
recording mode (XP, SP, LP or EP).
To record sound using LPCM (XP mode only):
Set the “Audio Mode for XP Recording” to “LPCM” in the
SETUP menu ( page 49).
5 Press [¥ REC] to start recording.
Recording will take place on open space on the HDD or on
disc. Data will not be overwritten.
You cannot change the channel or recording mode during
recording.
[HDD] [RAM] You can change the audio being received by
pressing [AUDIO] during recording. (Does not affect the
recording of audio.)
To stop recording
Press [].
From the start to the end of the recording is called one title.
[HDD]
When continuously recording for long durations, titles are
automatically divided every 8 hours.
[DVD-R]
It takes about 30 seconds for the unit to complete recording
management information after recording finishes.
To pause recording
Press [;].
Press again to restart recording.
(Title is not split into separate titles.)
When transferring (dubbing) in high speed mode to DVD-R
after you have recorded to the HDD.
When transferring (dubbing) a title using the high speed mode to
a DVD-R, set “DVD-R Rec for High Speed mode” to “On” before
recording to the HDD ( page 48).
However, the following restrictions apply.
When recording bilingual broadcasts, only the audio selected in
“Bilingual Audio Selection” ( page 49) is recorded (“M 1” or
“M 2”).
Even 16:9 aspect (Widescreen) programmes are recorded in
4:3 aspect.
Even if “Hybrid VBR Resolution” is set to “Automatic”, it
changes to “Fixed” automatically, and the “Automatic” setting
does not work ( page 48).
When recording to DVD-R
When recording bilingual broadcasts, only the audio selected in
“Bilingual Audio Selection” ( page 49) is recorded (“M 1” or
“M 2”).
In order to play a DVD-R recorded using this unit on
another playback source, the disc must first be finalized
( page 45).
OPEN/CLOSE
REC
/
x
1.3
TIME SLIP
CH
TIME SLIP
DRIVE SELECT
SD PCDVDHDD
SD CARD PC CARD EJECT
HDD DVD
215
TIME SLIP
3
∫1
VOLUME
CH
DIRECT TV REC
DVD
TV
AV
123
456
78
0
9
MANUAL SKIP
CH
CANCEL
INPUT SELECT
SKIP
STOP
PAU SE
PLAY/x1.3
SLOW/SEARCH
FUNCTIONS
ENTER
DIRECT NAVIGATOR
TOP MENU
RETURN
SUB MENU
CREATE
CHAPTER
TIMER
EXT LINK
PROG/CHECK
REC MODEERASE
REC
AUDIO
TIME SLIP
STATUS
DISPLAY
F
A B C
DUBBING
HDD DVD
SD/PC
3,4,2,1
ENTER
¥ DIRECT
TV REC
INPUT SELECT
STATUS
DIRECT
NAVIGATOR
F TIMER
;
1
FUNCTIONS
RETURN
TIME SLIP
AUDIO
5
3
1
4
VIDEO Plus+
HDD, DVD indicator
Numbered
buttons
Time Slip indicator
e.g., 5: [0] [5]
15: [1] [5]
Insert with the arrow facing in.
Insert fully so it clicks into place.
Insert label-up.
Remaining time on the disc
7467en.book18ページ2004年4月23日 金曜日 午前9時51分

Table of Contents

Related product manuals